Feedback Indicators#
Buzzer control#
mute#
* high volume#
medium volume#
low volume#
* high pitch#
low pitch#
* SDK voice response off#
SDK voice response enabled#
Base connection buzzer prompt switch#
Vibration motor control#
Note
The vibration motor works with a beep prompt, not all models support this feature.
Disable#
Enable#
Buzzer sound definition#
| Type | Sound | Description | Preview |
|---|---|---|---|
| Prompt Tone | One beep (two tones) | Storage mode decode; power-off prompt. | Storage mode decode
Power off
|
| Prompt Tone | One beep (three tones) | Power-on prompt; setting saved; upload complete. | Power on
Setting saved
|
| Prompt Tone | One short beep (same tone) | Successful barcode decode. | Successful barcode decode
|
| Prompt Tone | Short beeps for 30 seconds | Wait for the receiver in 2.4G pairing mode; stops after pairing succeeds. | 2.4G pairing
|
| Alarm Tone | Two beeps (same tone) | Low-battery alarm during decoding. | Low battery
|
| Alarm Tone | Three beeps (same tone) | Inventory storage error or storage capacity exceeded. | Storage error or capacity alarm
|
| Alarm Tone | Transmission failure | Alarm when barcode transmission fails. | No audio available |
| Alarm Tone | Five beeps (same tone) | Power-on failure caused by low battery. | Power-on failed due to low battery
|
Indicator definition#
Indicator |
Status |
|---|---|
red light / green light |
When charging, the red light is on and the green light is off; when fully charged, the red light is off and the green light is on. |
blue light |
Following the buzzer action, the buzzer lights up when it sounds and goes out when it does not sound; models that support Bluetooth mode are also used to indicate the Bluetooth connection status. |