System Settings#
Start#
Manual Instructions#
This manual includes symbology settings, function settings (lighting, keyboard type and factory reset, etc.) and interface settings. If you need to change the functions you need, just scan the configuration according to the setting barcode below. All with (*) indicate factory default values.
Version Information#
In order for the host to quickly read the version information of the current device, you can confirm it by reading the “version information”.
Version Information#
Set Code Switch#
By turning on the setting barcode function, you can configure the parameters of the scan engine by scanning the setting barcode.
Note
When modifying the configuration through the setting barcode, the entire current flag bit list will be saved to the memory, that is, the configuration configured through the serial port but not saved will also be saved together.
Disable# |
* Enable# |
Set Code Content Output#
Whether to output the setting barcode content, you can configure the parameters of the scan engine by scanning the following setting barcode.
* Disable# |
Enable# |
User Default Settings#
Save Current Configuration As User Default# |
Restore User Factory Default Settings# |
Users can save their frequently used configurations as user default settings. By scanning “Save current settings as user default settings”, the current configuration information of the device can be saved as user default settings information. After this operation, the new configuration information will replace the original user default settings information. By scanning “Restore User Default Settings”, the scan engine can be switched to user default settings.
Power Control#
Sleep Mode#
This parameter determines the power mode of the module. In sleep mode, the scan engine enters sleep state as much as possible (can be awakened by wake-up command)
* Sleep Mode#
Continuous Working Mode#
In continuous working mode, the scan engine is still awake after each decoding attempt.
Continuous Working Mode#
Prompt Output#
Prompt Sound Related#
Beeper Type#
Read the following setting barcode to set the buzzer as a passive or active buzzer.
* Passive# |
Active# |
Volume Level#
Users can adjust the buzzer volume according to the application environment and personal habits by reading the following setting barcode.
mute# |
Bass# |
Alto# |
* Treble# |
Power-on Beep#
Disable# |
* Enable# |
Setup Code Prompt Tone#
Disable# |
* Enable# |
Decoding Tone#
Disable# |
* Enable# |
Decoding Prompt Tone Frequency#
The resonant frequency of the buzzer used by the user may be different from the default frequency. You can adjust the frequency of the decoding prompt tone by reading the following setting barcode. Default is 2700Hz.
Scan the “Buzzer Frequency” setting barcode
Buzzer Frequency#
Scan the “Digital Setup Code”. For example, if the frequency is 1500Hz, sweep 1, 5, 0, 0; if the frequency is 2700Hz, sweep 2, 7, 0, 0
Scan the “OK” setting barcode to end the setting
Sure#
Decoding Prompt Sound Quick Setting#
1000Hz# |
1500Hz# |
2000Hz# |
2500Hz# |
*2700Hz# |
3000Hz# |
3500Hz# |
Decoding Tone Duration#
Users can set the duration of the decoding prompt sound as needed, the default is 50ms.
Scan the “Beep Sound Duration” setting barcode
Prompt Tone Duration#
Scan the “Digital Setup Code”. For example, if the duration is 50ms, scan 5,0; if the duration is 200ms, scan 2,0,0
Scan the “OK” setting barcode to end the setting
Sure#
Quickly Set The Decoding Tone Duration#
30ms# |
*50ms# |
70ms# |
100ms# |
200ms# |
300ms# |